Taking the 93 sc2 out to Proving Grounds at the end of this month to test out the progress. I'm open to suggestions that would improve handling & engine performance. Car is in beautiful condition, sat inside a garage for 12+ years, and when it was driven new, 1,000 mile intervals when changing oil. The owner was a car guy with monies, and gave it to his old fat friend who drove it for a month before it sat outside his shed and ruined the clearcoat, hence the rattle can. Regar...dless, short list of new part

[SixthSphere.com]

Taking the 93 sc2 out to Proving Grounds at the end of this month to test out the progress. I'm open to suggestions that would improve handling & engine performance. Car is in beautiful condition, sat inside a garage for 12+ years, and when it was driven new, 1,000 mile intervals when changing oil. The owner was a car guy with monies, and gave it to his old fat friend who drove it for a month before it sat outside his shed and ruined the clearcoat, hence the rattle can. Regar...dless, short list of new parts/mods. -Aftermarket shifter -Aftermarket steering wheel -17" Kosei k1 racing rims ( have saab and saturn 15" blades with winter tires ) -Eibach lowering springs -KYB struts -SPS Cold Air Intake -Hotshot header/downpipe 2 1/2"-2 1/4" piping to a fat GodSnow can ( straight piped ) -SPS front stabilizer bar -Ported throttle body -Catch can -New ECTS, Clutch Master cylinder, Thermostat, Water pump, NGK spark plugs, (cleaned plugs/wire connectors), New top motor mounts reinforced with a polyurethane type sealant, I quit writing my mods down, but this should be it. As you know the 1.9's throw heat, so I've been running w/o a hood, but probably will fabricate something for more ram air. Fluid flush, front brakes, compression check, and all the aestetically pleasing stuff will be done as well, paint, polish, under glow, interior glow, aftermarket dash /w lights, and hopefully some more Ricky Bobby tributes! -NA build in progress in my basement -Turbo build to start after the races(just needs to be installed) If you are interested in any 1st gen parts shoot me a message, located Duluth mn, have a full engine, lots of interior pieces, and 2 green doors!











(Feed generated with FetchRSS)

More...