ok this is what i got.
32 EGR system problem
26 quad drive module failure
23 manifold air temp. too low
75 Info flag-air temp. unstable
27 Info flag-quad driver fault
83 Info flag-low coolant level
Troubleshooting tips.
23
IAT temp (c degrees) -45
located before air box on snorkel. May be set if IAT is disconected and switch is cycled on.
If scanner is reading less then -22 (degrees) IAT may be disconected or broken off sensor.
32
Caused by sticking linear EGR valve pintle. Remove and depress pintle. If pintle sticks, binds, or fails to completly close, replace linear EGR valve
26
PCM is sensing a fault in any if eight output circuts
didnt have time to look them all up but thats what i got. My teacher told me i have a bad computer, saying something about the Quad driver inside the computer being bad and i should just go get a new one from a junkyard. Also im aware of the low coolant and why it sets up that code.
So the question...
should I change my computer or what else could be causing those codes to come up?
32 EGR system problem
26 quad drive module failure
23 manifold air temp. too low
75 Info flag-air temp. unstable
27 Info flag-quad driver fault
83 Info flag-low coolant level
Troubleshooting tips.
23
IAT temp (c degrees) -45
located before air box on snorkel. May be set if IAT is disconected and switch is cycled on.
If scanner is reading less then -22 (degrees) IAT may be disconected or broken off sensor.
32
Caused by sticking linear EGR valve pintle. Remove and depress pintle. If pintle sticks, binds, or fails to completly close, replace linear EGR valve
26
PCM is sensing a fault in any if eight output circuts
didnt have time to look them all up but thats what i got. My teacher told me i have a bad computer, saying something about the Quad driver inside the computer being bad and i should just go get a new one from a junkyard. Also im aware of the low coolant and why it sets up that code.
So the question...
should I change my computer or what else could be causing those codes to come up?
Comment