Announcement

Collapse
No announcement yet.

Will a '98 02 sensor on a '93 cause problems??

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Will a '98 02 sensor on a '93 cause problems??

    With the installation of the OBX header I had to go to a '98 02 sensor as the 1st gen sensor was too small to fit in the OBX welded bung.

    I am curious if this causes any problems for the computer to read as my air/fuel guage when I had the same engine w/92 header read normal (rich on WOT, and the normal fluctuation between rich and lean, etc..) and now with the same engine and the OBX with this '98 02 sensor, the A/F guage stays put in the stoich to rich range.

    Does anybody have any input on this???

    -Seann.
    1993 SW2 - Slow and Low

  • #2
    There should be no problems. Its the same sensor...just a different thread pattern. If you have any problems, then you got a bad sensor to begin with.
    -6S Resident Mechanical Forensics member #001.
    1995 SC2 Turbo 3.6L DOHC, 6sp manual, Ford 8.8 rearend running on MS3x.
    1998 F-250 5.4L triton...stock.

    Comment


    • #3
      Originally posted by S.Bretz
      There should be no problems. Its the same sensor...just a different thread pattern. If you have any problems, then you got a bad sensor to begin with.
      Okay, I figured as much considering they are both one wire sensors.

      I may grab a new one and try it out. Thanks Sam.
      1993 SW2 - Slow and Low

      Comment


      • #4
        YOu can get one of the universal ones for about $20, only thing is: You have to cut the old connector off and crimp it to the new sensor. There will be some easy to follow direction. Its and easy way to save $20-$40.
        -6S Resident Mechanical Forensics member #001.
        1995 SC2 Turbo 3.6L DOHC, 6sp manual, Ford 8.8 rearend running on MS3x.
        1998 F-250 5.4L triton...stock.

        Comment


        • #5
          Originally posted by S.Bretz
          YOu can get one of the universal ones for about $20, only thing is: You have to cut the old connector off and crimp it to the new sensor. There will be some easy to follow direction. Its and easy way to save $20-$40.
          Modification is no problem. Just go to Napa or Vatozone and look for a universal for Saturn?? Or universal in general?
          1993 SW2 - Slow and Low

          Comment


          • #6
            97 SC2 universal one wire header 02 sencor... dont get pre/after cat

            thats what i asked for at pepboys, 17$

            Comment

            Related Topics

            Collapse

            There are no results that meet this criteria.

            Working...
            X
            😀
            🥰
            🤢
            😎
            😡
            👍
            👎